Time-lapse thermography for building defect detection

Matthew Fox, David Coley, Steve Goodhew, Pieter De Wilde

OAI: oai:purehost.bath.ac.uk:openaire_cris_publications/dc1089f4-38d2-4daf-9884-2c2eac908ed2 • DOI: https://doi.org/10.1016/j.enbuild.2015.01.021

Building thermography traditionally captures the thermal condition of building fabric at one single point in time, rather than changes in state over a sustained period. Buildings, materials and the environment are, however, rarely in a thermal equilibrium, which therefore risks the misinterpretation of building defects by employing this standard methodology. This paper tests the premise that time-lapse thermography can better capture building defects and dynamic thermal behaviour. Results investigating the temporal resolution required for time-lapse thermography over two case study houses found that under typical conditions small temperature differences (approximately 0.2 K) between thermal areas could be expected for 30-min image intervals. Results also demonstrate that thermal patterns vary significantly from day-to-day, with a 2.0 K surface temperature difference experienced from one day to the next. Temporal resolutions needed adjusting for different types of construction. Time-lapse experiments raised practical limitations for the methodology that included problems with the distance to target and foreground obstructions. At the same time, these experiments show that time-lapse thermography could greatly improve our understanding of building transient behaviour and possible building defects. Time-lapse thermography also enables enhanced differentiation between environmental conditions (such as clear sky reflections), actual behaviour and construction defects, thereby mitigating the risk of misinterpretation.

Defect detection Time-lapse thermography Transient behaviour